Block BMS / Stepdown Regulator

Block BMS / Stepdown Regulator

14 September 2019 0 By Argonothe

Construction today of the BMS block.

Let’s start with a time laspe 8 hours 30 3D print summarized in just over 6 minutes of video …

Capture of 2019-09-14 08-56-02
IMG-20190914-175652
IMG-20190914-175701
IMG-20190914-180017
IMG-20190914-175724
IMG-20190914-175738
IMG-20190914-175758

Previous
next

Adjusting the control stepdown.

Two adjustments are possible, the voltage and the maximum intensity delivered.

First of all, we will only adjust the voltage.

Sense of knob setting: to the right (increase), to the left (decrease), the knob (CV) is used to adjust the voltage (exit side), the knob (CC) is used to adjust the current (entrance side).

We will set the output voltage to about 12V, we will make an adjustment if necessary when the mobile power supply is connected to the astrophotography setup.



It now remains to fix the stepdown/regulator with the screws and sins.